Hello,
I've tried twice and failed to produce a working DVD to install CentOS 7 and I am not sure what is going wrong.
I cannot find any information on the download page or in the FAQ that deals with this issue.
When I attempt to burn the .iso I am presented with the following error:
If I choose "Overburn" the entire burn fails. If I choose "Truncate" I get the following error when attempting to boot:
I fail to understand why the image is just a bit too big to burn.
Can someone point me in the right direction?
Thanks in advance.
Install DVD creation support
Re: Install DVD creation support
It requires a dual layer DVD which is twice as large as a normal one.
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
-
- Posts: 2
- Joined: 2020/05/18 01:42:21
Re: Install DVD creation support
Yes, it's the difference between base 10 and base 2, GB vs GiB. 4700000000 = 4482MiB = 4.37GiB.
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Re: Install DVD creation support
Probably not recommended, the CentOS 7.7 iso should fit.
If you do so, run yum update immediately after installation.
If you do so, run yum update immediately after installation.