connecting two servers acroos wifi router

[wall_545]

Hi, i have two laptops each one with centos 7, connected to a router by wifi.
First L1
gateway: 192.168.190.2

Code: Select all

Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default            gateway         0.0.0.0            UG    100    0        0 ens33
192.168.190.0   0.0.0.0         255.255.255.0   U     100    0        0 ens33
Second L2
gateway: 192.168.5.2
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
default            gateway         0.0.0.0            UG    100    0        0 ens33
192.168.5.0     0.0.0.0          255.255.255.0    U      100    0        0 ens33

no firewall in boith centos

both have ping to router. 192.168.1.1, but cannot ping from L1 to L2 or L2 to L1, the question is, which n route is needed to add, or is necessary to create a bridge or vlan by Network Connections or what, thanks

[TrevorH]

Why are your laptops on totally different subnets?

[wall_545]

i don't know, i only connected each one to wifi, that's it

[TrevorH]

Are they obtaining their ip address information via DHCP or did you set it up with static (fixed) ip addresses?

Also, I just spotted that your interface name on both is called ens33 and that is not a wireless interface name, it's a wired one.

[wall_545]

i forgot to say that both L1 and L2 are vmware VM's, ens33 is the default device, as static or as dhcp the behaviour is the same, no ping between them, i tried to assign, static ip's in both in the same sublan, but nothing, same behaviour, i'm not secure if i must change anything in the wifi router or add some route or virtual card.

[TrevorH]

Start again and this time describe the actual setup.

[wall_545]

the setup is the same L1 and L2, both are VM's
First L1:
Destination Gateway Genmask Flags Metric Ref Use Iface
default gateway 0.0.0.0 UG 100 0 0 ens33
192.168.190.0 0.0.0.0 255.255.255.0 U 100 0 0 ens33

Second L2:
gateway: 192.168.5.2
Destination Gateway Genmask Flags Metric Ref Use Iface
default gateway 0.0.0.0 UG 100 0 0 ens33
192.168.5.0 0.0.0.0 255.255.255.0 U 100 0 0 ens33

[wall_545]

i found the answer, setting both cards in mode bridged, it works, thanks