Hey guys!
I am super super new to Linux and I’m trying to install drivers for my motherboard Gigabyte Z690 UD DDR4 and I’ve installed kernel package.
If I try to boot the grub with it it gets stuck in this:
Boot stuck after kernel install
Re: Boot stuck after kernel install
What exactly did you do? The exact commands that you ran in what sequence.
Did your system ever boot CentOS 7? If so then that kernel is almost certainly still installed and you can choose it when you first see the CentOS boot prompt (grub) just by hitting the down arrow to choose an older on.
Did your system ever boot CentOS 7? If so then that kernel is almost certainly still installed and you can choose it when you first see the CentOS boot prompt (grub) just by hitting the down arrow to choose an older on.
The future appears to be RHEL or Debian. I think I'm going Debian.
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 and 6 are deadest, do not use them.
Use the FAQ Luke
Re: Boot stuck after kernel install
Hi Trevor,
Here are the commands, after installing elrepo rpm:
sudo rpm -Uvh https://www.elrepo.org/elrepo-release-7 ... noarch.rpm
sudo yum --enablerepo=elrepo-kernel install kernel-ml
sudo reboot
I can boot CenotOS7 on the older grub but I need the package for the drivers.
Would you be able to advise?
Here are the commands, after installing elrepo rpm:
sudo rpm -Uvh https://www.elrepo.org/elrepo-release-7 ... noarch.rpm
sudo yum --enablerepo=elrepo-kernel install kernel-ml
sudo reboot
I can boot CenotOS7 on the older grub but I need the package for the drivers.
Would you be able to advise?