Network configuration using kickstart UEFI mode

General support questions
Post Reply
paagalladka
Posts: 1
Joined: 2020/07/07 07:20:43

Network configuration using kickstart UEFI mode

Post by paagalladka » 2020/07/07 07:40:00

Hello everyone, I am trying to build custom ISO with kickstart for automated installation.

Bellow is part of ks.cfg outside of %pre

Code: Select all

# Network information
network  --bootproto=static --device=eth0 --gateway=10.8.25.1 --ip=10.8.25.230 --nameserver=8.8.8.8,4.4.4.2 --netmask=255.255.255.0 --ipv6=auto --activate
network  --bootproto=dhcp --device=eth1
network  --bootproto=dhcp --device=eth2
network  --bootproto=dhcp --device=eth3
network  --hostname=localhost.localdomain
I also have some code %pre section for partition

Now everything works fine if system boots in legecy mode, but as soon as I try UEFI mode
the network configuration part does not work and creates a device named ens33.

I am still new with centOS install process so I don't know at which staze network is being
initialized and how to avoid it create my custom interfaces with names like eth0/eth1..

Thanks

UPDATE: Sorry it was a silly mistake from my side. Resolved it with "biosdevname=0 logo.nologo" in grub conf.

Post Reply

Return to “CentOS 7 - General Support”