Hello,
Installed on the notebook CentOS.
During installatation on the point where it is needed to define partitions
- I did delete all Unknown partitions except BIOS boot and EFI System Partitions
- and created CentOS Linux x86_64 xfs partitions for /home, /, /boot and swap.
After system is installed I do reboot. But procedure stopped and report me that I should put boot device and press Enter.
Is this something wrong with UEFI and BIOS?
I plant to use only Linux on this notebook. Windows planning to use as virtual image under KVM when CentOS is fully functional.
So I do not need non Linux partitions.
Is there a way to tell the system to make /boot as primary bootable image?
CentOS 7.0 not boot after install
General support questions
Return to “CentOS 7 - General Support”
Jump to
- CentOS General Purpose
- ↳ CentOS - FAQ & Readme First
- ↳ Announcements
- ↳ CentOS Social
- ↳ User Comments
- ↳ Website Problems
- CentOS 8 / 8-Stream / 9-Stream
- ↳ 8 /8-Stream / 9-Stream - General Support
- ↳ 8 /8-Stream / 9-Stream - Hardware Support
- ↳ 8 /8-Stream / 9-Stream - Networking Support
- ↳ 8 /8-Stream / 9-Stream - Security Support
- CentOS 7
- ↳ CentOS 7 - General Support
- ↳ CentOS 7 - Software Support
- ↳ CentOS 7 - Hardware Support
- ↳ CentOS 7 - Networking Support
- ↳ CentOS 7 - Security Support
- CentOS Legacy Versions
- ↳ CentOS 5
- ↳ CentOS 5 - General Support
- ↳ CentOS 5 - Software Support
- ↳ CentOS 5 - Hardware Support
- ↳ CentOS 5 - Networking Support
- ↳ CentOS 5 - Server Support
- ↳ CentOS 5 - Security Support
- ↳ CentOS 5 - Oracle Installation and Support
- ↳ CentOS 5 - Miscellaneous Questions
- ↳ CentOS 6
- ↳ CentOS 6 - General Support
- ↳ CentOS 6 - Software Support
- ↳ CentOS 6 - Hardware Support
- ↳ CentOS 6 - Networking Support
- ↳ CentOS 6 - Security Support