Hello community,
I was recycling an old AMD PC as a file server and installed centos 5.9 64 (I tried to install Centos 6 but it didn't detect the disk!). I was configuring samba but with no luck, then I read that samba version 3.0.33 was too old for w7 and to install samba3x. so I just remove samba [i]yum remove samba[/i] and then install samba3x [i]yum install samba3x[/i]. After that [i]service smb start[/i] fails and I don't know why as the are no errors in /var/log/messages.
If anybody could point me in the right direction I will be really thankful.
Regards,
Cesar.
service smb start fail after installing samba3x
Re: service smb start fail after installing samba3x
It seems it was my previous smb.conf
[root@samurai samba]# mv smb.conf smb.conf.bak
[root@samurai samba]# cp smb.conf.original smb.conf
[root@samurai samba]# service smb start
Starting SMB services: [ OK ]
And I don't know why as it pass testparm...
[root@samurai samba]# testparm smb.conf.bak
Load smb config files from smb.conf.bak
rlimit_max: increasing rlimit_max (1024) to minimum Windows limit (16384)
Processing section "[multimedia]"
Loaded services file OK.
Server role: ROLE_STANDALONE
Press enter to see a dump of your service definitions
[root@samurai samba]# mv smb.conf smb.conf.bak
[root@samurai samba]# cp smb.conf.original smb.conf
[root@samurai samba]# service smb start
Starting SMB services: [ OK ]
And I don't know why as it pass testparm...
[root@samurai samba]# testparm smb.conf.bak
Load smb config files from smb.conf.bak
rlimit_max: increasing rlimit_max (1024) to minimum Windows limit (16384)
Processing section "[multimedia]"
Loaded services file OK.
Server role: ROLE_STANDALONE
Press enter to see a dump of your service definitions
Re: service smb start fail after installing samba3x
Did you ever get this resolved? I am having the same exact problems. I'm running CentOS 6.5. Nmbd starts just fine but the smbd doesn't.