centos 6 issue with HP proliant

Issues related to hardware problems
Post Reply
Posts: 4
Joined: 2018/08/16 12:49:58

centos 6 issue with HP proliant

Post by heindall_br » 2018/08/16 12:59:31

Hi all,

I have an issue with the following logs in a HP Proliant ML30:

kernel: dmar: DRHD: handling fault status reg 2
kernel: dmar: INTR-REMAP: Request device [[00:00.0] fault index 13
kernel: INTR-REMAP:[fault reason 38] Blocked an interrupt request due to source-id verification failure

I traced this to the following article where the workaround is to add the below parameter to the kernel:

https://support.hpe.com/hpsc/doc/public ... 19143en_us

I tried to add this parameter using sysctl but this parameter doesnt exist yet so I get an error.

Could you give me some lead to add this ?


User avatar
Forum Moderator
Posts: 29433
Joined: 2009/09/24 10:40:56
Location: Brighton, UK

Re: centos 6 issue with HP proliant

Post by TrevorH » 2018/08/16 13:25:51

It's not a sysctl, it's a kernel parameter that you need to append to the kernel command line in grub.conf then reboot
CentOS 6 will die in November 2020 - migrate sooner rather than later!
Info for USB installs on http://wiki.centos.org/HowTos/InstallFromUSBkey
CentOS 5 is dead, do not use it.
Full time Geek, part time moderator. Use the FAQ Luke

Post Reply

Return to “CentOS 6 - Hardware Support”