CentOS

Think the subject covers it all. ifcfg-eth0 is there but when I do service 'network restart' it starts loopback but that is all, it does not even try eth0.

This is driving me nuts. Ive now installed CentOS around 7 times and had no luck. The reason i am using 6.10 is it has to match a production server. I used the minimal install ISO.

The liveDVD works fine (it can access websites through Firefox).

Ben

What is the output from grep ONBOOT /etc/sysconfig/network-scripts/ifcfg-eth0 ?

ONBOOT=no

In other thisng is MM_CONTROLED=yes, which seems wrong but changing this does not work.

I also tried doing a full desktop install, which worked (using 'install to hard drive' from liveDVD) but when I used yum to uninstall Desktop components it stooped working. I suspect it was using NetworkManager and works with this but without it there is something wrong.

Ben

As I see you discovered from another thread, ONBOOT=no is the problem. It's part of the CentOS FAQ...

when you changed it to 'yes' did you reboot or at least start the device with 'ifup eth0' as root?

- after that, out of ideas

What's your NIC, and can you check if the corresponding module is loaded?

From another thread: he got it working. This one is dead.

Sorry, posted to wrong thread.

"Got it working, ONBOOT=yes, MM_CONTROLED=no"

Ben

POOP! I totally didn't 'connect' the network service comment and the NM_CONTROLLED.