Search found 5 matches

by MHamas
2021/02/19 11:59:33
Forum: CentOS 7 - General Support
Topic: Centos 7 Connectivity Issues in VMware Workstation
Replies: 2
Views: 153

Re: Centos 7 Connectivity Issues in VMware Workstation

I mentioned in the post that I was trying to ping different subnet which is on my host machine. You are right about the normal scenario that I will not be able to ping a different subnet (as per the basic networking), but this case is specific to VMware workstation where I mentioned that I have used...
by MHamas
2021/02/12 12:41:12
Forum: CentOS 7 - General Support
Topic: Centos 7 Connectivity Issues in VMware Workstation
Replies: 2
Views: 153

Centos 7 Connectivity Issues in VMware Workstation

Hi all, I am new to CentOS and this forum too so at my part I have tried to look up the issue that I have been facing but I haven't found any desirable results. If there is already same issue posted earlier than apologies, and I would request anyone to kindly guide me to it. Anyways, coming to the p...
by MHamas
2021/01/26 11:45:43
Forum: CentOS 7 - General Support
Topic: Server Requires Restart After Every Modification in Network
Replies: 5
Views: 182

Re: Server Requires Restart After Every Modification in Network

These were the exact commands except that I didn't mention the IP Addresses. But there you go, look at the commands below in sequence --> ip route add 192.168.61.200/16 via 192.168.61.254 dev eth0 --> vi /etc/sysconfig/network-scripts/route-eth0 --> 192.168.61.200/16 via 192.168.61.254 dev eth0 --> ...
by MHamas
2021/01/25 12:04:30
Forum: CentOS 7 - General Support
Topic: Server Requires Restart After Every Modification in Network
Replies: 5
Views: 182

Re: Server Requires Restart After Every Modification in Network

I am using the following command to add the route ip route add <ip-address>/<mask> via <gateway> dev eth0 after adding the route I access eth interface by using the following command vi /etc/sysconfig/network-scripts/route-eth0 In that, I add the following line <ip-address>/<mask> via <gateway> dev ...
by MHamas
2021/01/21 16:17:58
Forum: CentOS 7 - General Support
Topic: Server Requires Restart After Every Modification in Network
Replies: 5
Views: 182

Server Requires Restart After Every Modification in Network

Dear All, I am currently facing an issue that whenever I try to add a static route in my Centos 7, all the services stop working unless I restart my server. Service Network Restart is working properly and all eth interfaces restart properly but services go in halt unless server is restarted. If any ...

Go to advanced search